The easy-to-use Q Series Quick Connectors were designed for use with laboratory and portable test equipment, gauge calibration, sampling systems, biopharmaceutical applications, and gas distribution. Q, Keyed Q, and QF Series Quick Connectors are very easy to use. No tools are required to couple or uncouple Quick Connectors, and a minimum amount of equipment must be shut down. With Hy-Lok Quick Connectors, there is no possibility of over or under tightening, galling, or cross threading.
Hy-Lok Quick Connector sizes range from 1/4” to 1” wide. They are rated for use in environments as cold as -10°F (-23°C) and as hot as 400°F (204°C). They can handle a working pressure of up to 6,000 psig (413bar).
Exact Quick Connector specifications vary based on series, model, material, and other factors. Be sure to check the specifications of the precise models that you are considering using.
Hy-Lok recommends that filters always be used with Quick Connectors, and that uncoupled Quick Connectors be protected with dust caps or body and stem protectors. Hanging hoses should be supported to prevent side load. Stem seal O-rings should be lubricated regularly.
Coupling and uncoupling should always be performed during system cleaning and at room temperature. Be sure to keep body and stem aligned while coupling and uncoupling.
If you have any questions about any of our products or services, don’t hesitate to give us a call. For any inquiries, fill out the form and one of our Hy-Lok representative will contact you soon.